Is A Lay‑Z‑Spa Easy to Look After?


Why Does My Jetted Tub Smell Like Rotten Eggs?

Is A Lay‑Z‑Spa Easy to Look After?

A Lay‑Z‑Spa is a great way to spend time in the sun, but they need some upkeep if you want them to work at their best.

You can take care of it yourself or have a professional service company come out and do it for you.

It would help if you did everything right so that your Lay-Z Spa stays in perfect condition for years of enjoyment.

Is A Lay‑Z‑Spa Easy to Look After?

A Lay‑Z‑Spa is easy to look after with these simple steps!

*Treat the water with chlorine shock, leave for 6 hours, then adjust the pH to 7.2 and 7.5 using a pH increaser or acidifier.

*Add floating chlorine tablets when in use each day or if not in use for over four days.

*Keep the pump filter clear – remove debris from the filter cartridge after each use. Clean using a cleaning brush if required.

*Stop the airflow to the hot tub at least once per week for 20 minutes by

  • Turning off all air jets,
  • Closing valves
  • Partially covering it with a towel to allow any built-up gases to escape

*Close nozzle valve on pump cover when not in use. This will help prevent any rainwater run-off from contaminating the water in your Lay-Z‑Spa

*Clean the outside of your spa with a soft cloth or brush, then wipe dry. Removing any stubborn stains with a diluted bleach solution

* You can leave a Lay‑Z‑Spa hot tub all year outdoors round, but please ensure that you cover it when not in use to protect it against leaves and other debris falling into the hot tub.

*You should carry out cleaning using a suitable cleaner, following usage every four weeks. Chlorine tablets should also get replaced after this time.

Can You Leave the Lay-Z‑Spa Pump Running All the Time?

YES! The only times you would want to shut it off are when you’re using your Lay-Z Spa or if it’s getting too cold outside.

If you’re not using your Lay-Z Spa, the manufacturer strongly recommended that you leave the pump running all the time.

This will ensure that the water is constantly circulating and heating, even when no one has used it for a while.

When leaving your Spa this way, it’s best to keep the lid open so that heat can escape.

As long as it doesn’t get too cold outside, it would help if you didn’t have to shut off your filter pump between uses.

If someone plans to use their spa for many consecutive hours at once.

Here, they should turn off their filter pump until they’re done using it and then turn it back on before anyone gets in again.

Doing this prevents heat loss and ensures that the water is undergoing filtration.

If you want safety, keep your filter pump on at all times by filling it with antifreeze or using an outdoor Lay-Z Spa heater.

How Long Is the Warranty on A Lay‑Z‑Spa?

Lay-Z-Spa has a 24-month warranty on their products as standard. This is the typical warranty length for spas and hot tubs.

It’s prevalent and means that you can rest easy for at least two years. Knowing your product will function without issues and won’t cost you anything to fix either.

If you run into any problems after the 2-year mark, contact Lay-Z-Spa’s customer service department.

They should be more than happy to help, but you must provide proof of purchase to claim the warranty. Keep your paperwork safe in case you need it.

Lay-Z-Spa’s warranty boasts hosting with Tevas Group Inc. They are a company that specializes in third-party warranties such as Lay-Z-Spa’s.

They offer their services as an intermediary between the two parties involved, allowing warranties to get honored with ease when necessary.

What happens when you lose your Lay‑Z‑Spa warranty papers?

If you lose your Lay‑Z‑Spa papers, there are a few things to do to get yourself back on track and use your spa again.

Please note: If you have lost the warranty card for your spa, buy a one-year extended warranty immediately (in conjunction with any existing warranties).

Big issue customers may miss when purchasing Spas like these is that they do not come with an owner’s manual. If you do not have the manual to rely on.

If you cannot find your owner’s manual online, you might contact the dealer who sold it to you.

The dealer may have a copy readily available or even an electronic version that can get emailed over.

If there is no warranty card inside the housekeeping folder, use the serial number on the rating plate inside of your Lay-Z-Spa.

You can find this at either end of your Spa. 

What If My Lay‑Z‑Spa Inflatable Hot Tub Gets A Puncture?

Ease your worries; it’s not the end of the world. All you need to do is find out where the leak is coming from and patch it up with some water-resistant tape or sealant.

Here’s a list of tips and advice:

* The water jets may need inspections for blockages if the tub isn’t filling up. To unblock or unplug them, you can use a pin to clear any obstructions.

If this doesn’t work, try using an old toothbrush instead, as it will provide more force than a pin.

* A malfunctioning water pump could also stop the tub from filling up.

If this is the case, confirm that there are no sharp objects lodged in it, such as twigs or stones, then try plugging it into another power supply if possible.

* Dirt trapped inside the filter system could also cause problems with water flow and jets not working correctly. Make sure you rinse the filter after every use.

* If you spot a split in one sidewall, make sure you find it and mark it with a permanent marker.

Once you finish this, place a stitch of waterproof tape over the leak using a sewing needle for extra grip.

If that doesn’t work, then you’ll want to take advantage of your warranty and contact the company’s customer to care for further help.

Can You Sell Internal Parts for The Pump?

Lay‑Z‑Spa does not currently sell any internal parts for their pumps, but it’s possible to purchase

The pump inside.

A standard 240V AC powers Lay-Z-Spa Pumps

A single-phase electric power supply that you can plug into any standard household power outlet.

This allows Lay-Z-Spa pumps to move water at high rates of speed and efficiency even when positioned quite some distance away from the home’s electrical panel.

A typical installation would have the pump in the pool, with the equipment within 50 ft (15 m) or so of an existing outdoor.

110 V 60 Hz electrical receptacle that delivers 20 A or more excellent capacity circuits.

The equipment should boast protection by a ground fault circuit interrupter (GFCI) type branch circuit breaker or a GFCI receptacle.

Lay-Z-Spa Pumps have a specific “start” and “stop” switch that must boast correct flipping correctly for the pump to turn on and off.

If you do not flip the switch correctly, no power will reach the pump. In addition, there are multiple steps required for the filter system to run successfully.

First, both air intake valves near the top of the pool must get opened before plugging in the pump itself.

Second, once plugged in, it is necessary to open up several valves on either side of the unit before pressing start on either switch.

Now that everything has become set up correctly with all valves open press the start switch to activate the pump.

Troubleshooting Lay-Z-Spa Pumps is very similar to most other brands of pool pumps.

First, make sure that all valves are open and that the power supply gets plugged into a live electrical circuit properly.

Check both switches on the side for any malfunction or damage.

If there is no power reaching the pump, either fuse may have blown, or an internal wiring problem could be present with the switches themselves.

If neither switch works but power is being supplied to them.

It would mean one of two things: either an internal wiring problem within the unit itself or an issue with the wires coming from the power source.

You can replace fuses by unplugging the pump and opening up its case. Locate the fuses in roughly the same area as a standard light switch.

One side of it should have silver screws, and the other side should have brass screws holding it inside. Change out the old with a new fuse and close it back up.

If there is still no power reaching the pump at all, regardless of what position both switches are in.

Check the electrical power source for any problems, such as insufficient voltage or poor grounding.

If there is enough voltage, but nothing is happening regardless of both switches flipping on/off, either pump has an internal problem or wiring from circuits to start and stop switches may need repair.

Can I Leave My Lay‑Z‑Spa Unattended For A Long Time?

Yes. The manufacturers recommend you drain the spa below the jets if left unattended for an extended time.

This will help prevent freezing issues in colder climates. If drained, you can top it up after use, check levels regularly, and top up when necessary.

Experts recommend you not leave the spa empty (do not use water from a garden hose to top up).

Using the jets with no water in the spa could damage them and void any warranty claims if they become faulty.

This also applies to hot tubs that boast covering while not in use.

The cover can trap moisture and cause it to freeze (this may damage the insulation and seal around the cover).

We recommend removing the cover when you leave your spa unattended.

Note: An automated air blower should boast fitting to allow air into the system. This would prevent freezing within your unit.

Is the Lay-Z-Spa Pump and RCD Waterproof?

Yes, the Lay-Z-Spa Waterproof System gets designed to be IPX4 Water Resistant.

This means that your Lay-Z-Spa should withstand rain showers and jets of water from a garden hose with no problems. But you should not submerge your Lay-Z-Spa in water.

As well as being IPX4 Water Resistant, the Lay-Z-Spa Pump also includes an RCD (residual current device) which will protect users from electric shock when using the spa.

As long as you keep the pump dry at all times, you should have no problem using this product.

For added peace of mind, each pump comes with one year manufactures warranty against faulty artistry or components.

Please remember that if used outside, plug the Lay-Z-Spa into a GFI-protected circuit. This will protect your spa from power surges that could damage appliances plugged into it.

Conclusion

A Lay-z Spa is a great way to enjoy the outdoors and relax. They are easy to look after, but there are some things you need to know before bringing them home.

We’ve answered all your questions about what type of warranty they come with, how long they last for and if you can buy internal parts separately.

Tom

Hi! I' am Tom. I was a manager in one of the biggest stores for over 10 Years, am also an SEO by night. I don't like to call myself a blogger; they are very analytical, do email marketing, and know all SEO stuff. I faced many questions from customers about different products, and there was hardly any help on the internet. After learning all the things about these products as a manager the hard way, I decided to start a blog and help other people.

Recent Posts